Rock-slide-engineering R-SE JK BOMBSHELL KIT Bedienungsanleitung PDF herunterladen

Installation Instruction RSEI 117

R-SE JK BOMBSHELL KIT

AX-BS-100-D44

*If any parts listed are missing or damaged please call Rock-Slide Engineering @

435-752-4580 prior to installation.

JK DANA 30 axle. The outer sleeve kit will need some minor trimming to allow for

install.

JK DANA 30 axle. The inner sleeve kit will work as per the instructions.

JK DANA 44. The inner and outer kits will work as per the instructions.

It is easier to install the kit with the axle removed or with the vehicle on a hoist. It is

possible to install the kit with the axle installed in the Jeep, but some welds may be

harder to do without being able to move the housing. If the housing is assembled or

has the axle seals in place, welds near the differential housing will need to be done

incrementally in order to keep the heat down so the seals are not damaged. If done

slowly, 1.5”-2” at a time, and cooled in between welds, the seals will be fine.

Installation of the inner sleeve kit

1. Remove the necessary hardware to allow the inner sleeve to slide over the

axle.

2. Pre-drill ½” holes in the axle housing prior to installing the inner sleeve kit. Drill

approximately 10-15 holes in appropriate places to allow a plug weld to take

1 2

Installation Instruction RSEI 117 R-SE JK BOMBSHELL KIT AX-BS-100-D44 *If any parts listed are missing or damaged please call Rock-Slide Engineer

Seite 2

Installation Instruction RSEI 117 place. Be sure to distribute the holes appropriately to receive the maximum strength. 3. Plug weld the inner sleev

Keine Kommentare

Rock-slide-engineering R-SE JK BOMBSHELL KIT Bedienungsanleitung