Rock-slide-engineering TUNDRA SERIES – STEP SLIDER Bedienungsanleitung

Installation Instruction RSEI 131 Toyota Tundra Step Slider Installation BS-SS-100-TUN

Installation Instruction RSEI 131 14. Mount the ground from the cutoff switch to a metal

Installation Instruction RSEI 131 20. Position the actuating magnets on the catch side of each door

Installation Instruction RSEI 131 TROUBLE SHOOTING/FRICTION POINTS  The slider is powered by the truck’s battery when engine is off and power

Installation Instruction RSEI 131 PARTS LIST

Installation Instruction RSEI 131 *If any parts listed are missing or damaged please call Rock-Slide Engineering @ 435-752-4580 prior to installat

Installation Instruction RSEI 131 b. With bracket in the correct location, mark the location of the holes with a marker on the panel of the truck

Installation Instruction RSEI 131 9. Attach the top bracket to the truck a. Hang bracket on truck and bolt through bracket into the nutserts.

Installation Instruction RSEI 131 18. Attach the slider to the top bracket using the stainless steel bolts. Don’t forget to use the a

Installation Instruction RSEI 131 WIRING HARNESS INSTALL Step Slider Wiring Diagram Driver Side Wire Color Passenger Side Wire Color

Installation Instruction RSEI 131 1. Remove the sill plate covers on both driver and passenger rear doors 2. Lay

Installation Instruction RSEI 131 8. Inside the truck, route the rear passenger door sensor wire along the doorframe; and using a sticky pad, mou